Overview

H6 Heavy-Duty Hydraulic

Our H6 cylinder is built to handle the most rugged applications and is in high demand for clamping, stamping, forging, bending, tilt and shearing processes.

Bore Sizes From 1.5" - 24" 3,000 PSI

20 mounting styles.

JIC-NFPA Interchangeable

Common Industries: Built to last in the most rugged applications for example foundry, steel mills, stamping, plastics, paper and pulp, just to name a few.

Common Applications: Clamping, stamping, forging, bending, tilt and shearing

3 years Lmited Warraty

Manufactured in Michigan

CLICK HERE to visit our Cylinder Configurator.
For more information, call Yates Idustries at
(586) 778-7680

Features

1. Head/Cap: Precision machined steel head and cpa provide close concertricity and accurate alignment between piston, tube, piston rod and rod bearing.

2. Cylinder Barrel: Damage resistant, heavy wall steel tubing, honed to an 8 to 16 micro finish for low frictional drag and maximum seal and piston bearing life.

3. Rod Cartridge: Extra long, high strength bronze gland provides maximum bearing support and wear resistance. With certain exceptions, a removable retainer allows for gland removal without cylinder disassembly.

4. Piston: One piece fine grained cast iron piston provides maximum strength and protection against shock loads. Anaerobic adhesive is used to permanently lock and seal the piston to the rod.

5. Piston Rod: One piece fine grained cast iron piston provides maximum strength and protection against shock loads. Anaerobic adhesive is used to permanently lock and seal the piston to the rod.

6. Tie Rode: 100,000 to 125,000 PSI minimum yield steel, pre-stressed for fatigue resistance, and roll threaded for added strength.

7. Cushions: Head cushion sleeve and rear cushion spear are machined to close tolerances to provide a gradual deceleration and reduced shock at end of stroke.

8. Cushion Needle Adjustment & Bell Check: Flush mounted captive cushion adjustment allows for safe cushion adjustment under pressure. Special tip design and fine threads allow for precise adjustment over a broad range of operations. Cushion ball check allows for fast break-away under full power.

9. Tube End Seals: Flush mounted captive cushion adjustment allows for safe cushion adjustment under pressure. Special tip design and fine threads allow for precise adjustment over a broad range of operations. Cushion ball check allows for fast break-away under full power.

10. Ports: Flush mounted captive cushion adjustment allows for safe cushion adjustment under pressure. Special tip design and fine threads allow for precise adjustment over a broad range of operations. Cushion ball check allows for fast break-away under full power.

11. Rod Seals: Twin lip urethane rod seal is pressure energized and wear-compensating for long, leak-free service. Viton® seals are optional.

12. Piston Seals: Pressure energized nitrile U-cups with back-up rings are standard. Step cut cast iron rings and Viton® seals are optional.

13. Rod Wiper: Pressure energized nitrile U-cups with back-up rings are standard. Step cut cast iron rings and Viton® seals are optional.

Side Mounts

Side Mounts

End Mounts

End Mounts

Pivot Mounts - Clevis & Trunnion

Pivot Mounts

Ask a Question